Raspberry Pi

There are Tizonia binaries for Raspbian. All versions of Raspberry Pi are supported. Select the OMX.Aratelia.audio_renderer.alsa.pcm renderer as the default audio renderer in tizonia.conf.

CONFIGURATION

[tizonia]
# Tizonia player section

# The default audio renderer used by the tizonia player
# -------------------------------------------------------------------------
# Valid values are:
# - OMX.Aratelia.audio_renderer.pulseaudio.pcm
# - OMX.Aratelia.audio_renderer.alsa.pcm
default-audio-renderer = OMX.Aratelia.audio_renderer.alsa.pcm

This can also be done with this one-liner:

# Update tizonia's config
perl -pi -e 's/^(default-audio-renderer.*)pulseaudio/\1alsa/' $HOME/.config/tizonia/tizonia.conf

Tizonia on a headless Raspberry Pi

It is posible to run Tizonia on a headless Raspberry Pi (e.g. a Raspberry Pi Zero with Raspbian Lite).

Tizonia has a dependency against D-Bus but normally, the D-Bus daemon is not even started without X11. In this case, it is necessary to make sure that the D-Bus daemon has been started prior to using Tizonia.

See this recipe for an idea on how to launch the D-Bus daemon on your headless Raspberry Pi.